Retrofit kit for an aftermarket rear view camera for VW T6 Dropside including display or connection adapter for display on the radio/navigation unit
With this vehicle-specific retrofit kit, you can professionally retrofit a rear view camera to your VW T6 Dropside. Depending on the selected version, the camera image is displayed either on a separate 5-inch or 7-inch monitor or directly on the original radio or navigation system. The available cameras offer a wide viewing angle of the rear area, significantly simplify maneuvering and help you keep people, obstacles or the tow hitch in view at all times. The kit has been specifically developed for the requirements of dropside vehicles and includes all components required for installation, including a vehicle-specific wiring harness.
Product information:
- Premium color rear view camera for surface or flush mounting (depending on selection)
- Integrated infrared illumination for perfect night vision (depending on camera selection)
- The tow hitch ball is visible in the camera image
- The camera tilt angle is adjustable
- Guide lines: enabled by default (can be disabled by disconnecting the cable loop)
- E-mark, CE and FCC approval (depending on camera selection)
Scope of delivery:
- AMPIRE color rear view camera for surface or flush mounting (depending on selection)
- 5-inch display, 7-inch display or Plug & Play connection adapter for radio/navigation
- PWM signal filter (only for connection to a separate display)
- Pre-assembled wiring harness
- Installation instructions (German)
Installation time: approx. 4–5 hours
Notes on the connection variants:
Connection adapter for direct connection of the camera to the radio/navigation unit
Use this version ONLY if your VW T6 is equipped with one of the following radio or navigation systems. In this configuration, the rear view camera image is displayed on the radio/navigation screen when reverse gear is engaged, just like a factory-installed system.
- Navigation (PR numbers: 7UF, 7UP, 7UG, 7UH, 8AY)
- Composition Media (PR number: I8F in combination with PR number: 9WT or QV3)
- Composition Colour (PR number: I6V in combination with PR numbers: 9WT and QV3)
- Composition Media (PR number: I7A in combination with PR number: 9WT or QV3)
In this version, the rear view camera image appears on the radio/navigation display immediately after reverse gear is engaged. With this connection method, control unit 5F (Information Electronics) and control unit 10 (Parking Assistance, if installed) must be coded for rear view camera functionality. All necessary information is included in our instructions. Final coding is carried out using a standard diagnostic system according to our installation guide (e.g. VCDS, VCP, ODIS, etc.).
Connection variant including 5-inch or 7-inch display
Use one of these variants if your VW T6 is equipped with a radio that does NOT support rear view camera display. In this version, the rear view camera is activated via the reverse light signal and the image appears on the additional display immediately when reverse gear is engaged. Information about the available displays can be found under article numbers RVA051, RVA071, RVA072
Notes on the camera variants:
This retrofit kit is available in 4 different camera variants. The KIP100 and KIP200 are ultra-wide-angle cameras with an exceptionally large diagonal viewing angle of 205°, allowing virtually the entire rear area to be monitored depending on the installation position.
KC203 Rear View Camera (all 3 colors)
- Image sensor: SHARP 1/4'' Color
- Sensor type: CCD
- Video standard: NTSC
- Resolution in pixels: 512 x 492 (H x V)
- Resolution in lines: 420 TVL (Enhanced)
- Frame rate: 60Hz
- Light sensitivity: 0 Lux (IR illumination)
- Number of infrared LEDs: 10
- Lens aperture: 2.4 mm
- Horizontal viewing angle: 70°
- Vertical viewing angle: 50°
- Exposure time: 1/60~1/100,000 sec
- Signal-to-noise ratio >48dB
- Automatic white balance
- Automatic level adjustment
- Operating temperature: -30°C to +70°C
- Power consumption without IR illumination: 80mA
- Power consumption with IR illumination: 146mA
- Dimensions: 50 x 50 x 60 mm
- Protection class: IP67
- E approval: E13-10R00-10R02-3857-00
- CE: 960323L14,960323L13
KTX802 Rear View Camera:
- 2 different guide line modes: disabled by default (can be enabled)
- Matte black plastic housing with stainless steel bracket
- Mirrored image display (adjustable)
- 180° image rotation (adjustable)
- Image sensor type: 1/4'' 1233 HD Color CMOS Low Light Sensor
- NTSC video signal with 60 frames per second
- Resolution: 960H×480V pixels
- IP69K protection rating
- Resolution: 800 TV lines
- Exposure: 1/50-60~1/15000 seconds
- Signal-to-noise ratio =>46dB
- Dynamic range >>74dB
- Light sensitivity < 0.01 Lux/F1.2
- Output signal 1.0Vp-p, 75 OHM
- Automatic white balance
- Automatic video level adjustment
- Operating voltage 12V DC
- Power consumption 25-55mA
- Diagonal viewing angle 188°
- Horizontal viewing angle 155°
- Vertical viewing angle 113°
- Camera dimensions 20.7x20.7x17.8mm
- Operating temperature -40°C to +75°C
- Storage temperature -60°C to 105°C
- E-certified
- APPROVALS: CE Directive 2004/108/EC, EN55022:2010, EN55024:2010 Report No. STR12058091E, FCC Part 15B Report No. STR12058092E-3
Installation notes:
- Mount the rear view camera centrally in the rear area on the underride guard or lamp carrier
- Route the wiring harness into the passenger compartment and connect it either to the separate display (5 or 7 inch) or to the radio/navigation unit using the included Plug & Play adapter (depending on the selected version)
- Finally, code the vehicle for rear view camera functionality according to the included instructions (only for the "Connection adapter for radio/navigation unit" version)
Additional notes:
- The versions with a separate 5-inch or 7-inch display can be used without restriction in all VW T6.1 vehicles.
- The version with the connection adapter for displaying the rear view camera image on the radio or navigation screen is not compatible with all VW T6 models. Please observe the notes regarding connection variants and PR number compatibility.
-
NOT suitable for VW T6 panel vans, Transporter, Multivan, California, etc. For these vehicles, please use retrofit kit article number RVC-T6 or RVC-T6-ZUB
Professional installation required?
We also offer this item including installation at a fixed price (additional charge €429). Appointment requests can be made via our customer service (www.wibutec.com/kontakt). Please always include your vehicle identification number when making inquiries.
This product description has been translated automatically. The original and authoritative version is the German-language description. In case of any discrepancies or uncertainties, please refer to the German version.
German
Dutch
