Retrofit kit for retrofitting the original Audi Park Assist system in the Audi A1 GB
Suitable for all models equipped with front and rear parking sensors (PR equipment code 7X2)
Let your Audi A1 park itself! The original Audi Park Assist scans the left or right side of the road for a suitable parking space and notifies you once a sufficiently large space has been found. Now it’s time to take your hands off the steering wheel – from this moment, the PLA performs the parking maneuver for you!
⚠ Please provide the vehicle identification number (VIN) during the ordering process
Product details:
- No difference compared to the factory-installed park assist system
- Set includes original Audi sensors with mounting brackets
- Distances to obstacles are displayed visually
- Parking assistance is expanded to the environment display
- Acoustic feedback when obstacles are detected
- Automatic activation when reverse gear is engaged
- Automatic activation at the front when obstacles are detected
- PDC can additionally be activated via the button
- Various parking modes available in PLA mode
- Automatic parking space detection up to approx. 40 km/h
Compatibility:
- Suitable for all Audi A1 GB vehicles already equipped with front and rear parking sensors
Please also note the following very important information
This retrofit kit CANNOT be used in vehicles that are already protected with SFD2!!
SFD stands for "Protection of Vehicle Diagnostics". Many vehicles from approximately model year 2024 are already equipped with SFD2, and changes to the vehicle configuration are currently not possible via standard diagnostics. Further information about SFD and SFD2 and whether your vehicle is affected can be found at the following link >> click here <<
Scope of delivery:
- 2x Original Audi PLA sensor front
- 2x Original Audi mounting bracket for PLA sensor front
- 2x Original Audi PLA sensor rear
- 2x Original Audi mounting bracket for PLA sensor rear
- 1x Original Audi switch strip with PLA button (depending on equipment)
- 1x Original Audi PLA control unit
- 1x Wiring harness PDC front bumper
- 1x Wiring harness PDC rear bumper
- 1x Wiring harness PLA switch strip
- 1x Additional parts depending on the vehicle identification number, e.g. trims, etc.
- 1x Connection and coding instructions
Installation time: approx. 6–7 hours
Installation information:
- No replacement of the bumpers is required
- The sensors are installed in the existing bumpers; the positions are marked inside the bumper
- We recommend using a punching tool to create the openings; this can also be purchased or rented from us
- After installation, the vehicle must be coded for the new equipment; these steps are included in our instructions. For coding, use VCDS, VCP, ODIS, or another vehicle-compatible diagnostic tool
Notes:
- The retrofit kit is assembled by us based on the vehicle identification number and therefore specifically for your vehicle. You will receive all parts required for the retrofit. For this reason, the delivered contents may vary slightly and may differ from the parts shown in the photo
- If the sensors are ordered painted in vehicle color, the delivery time will be extended by 2 days
Installation service available?
We also offer this item fully installed at a fixed price (additional charge 579 EUR). To arrange an appointment, please contact us via our CONTACT FORM. Please always include your vehicle identification number when making inquiries.
German
Dutch